Optionaldata: PartialMessage<ModuleConfig_DetectionSensorConfig>Whether or not the GPIO pin state detection is triggered on HIGH (1) Otherwise LOW (0)
Whether the Module is enabled
Interval in seconds of how often we can send a message to the mesh when a state change is detected
GPIO pin to monitor for state changes
Friendly name used to format message sent to mesh Example: A name "Motion" would result in a message "Motion detected" Maximum length of 20 characters
Send ASCII bell with alert message Useful for triggering ext. notification on bell
Interval in seconds of how often we should send a message to the mesh with the current state regardless of changes When set to 0, only state changes will be broadcasted Works as a sort of status heartbeat for peace of mind
Whether or not use INPUT_PULLUP mode for GPIO pin Only applicable if the board uses pull-up resistors on the pin
Static ReadonlyfieldsStatic ReadonlyruntimeStatic ReadonlytypeCreate a deep copy.
Compare with a message of the same type. Note that this function disregards extensions and unknown fields.
Parse from binary data, merging fields.
Repeated fields are appended. Map entries are added, overwriting existing keys.
If a message field is already present, it will be merged with the new data.
Optionaloptions: Partial<BinaryReadOptions>Retrieve the MessageType of this message - a singleton that represents the protobuf message declaration and provides metadata for reflection- based operations.
ProtectedtoJSONOverride for serialization behavior. This will be invoked when calling JSON.stringify on this message (i.e. JSON.stringify(msg)).
Note that this will not serialize google.protobuf.Any with a packed message because the protobuf JSON format specifies that it needs to be unpacked, and this is only possible with a type registry to look up the message type. As a result, attempting to serialize a message with this type will throw an Error.
This method is protected because you should not need to invoke it directly -- instead use JSON.stringify or toJsonString for stringified JSON. Alternatively, if actual JSON is desired, you should use toJson.
StaticequalsStaticfromOptionaloptions: Partial<BinaryReadOptions>StaticfromOptionaloptions: Partial<JsonReadOptions>StaticfromOptionaloptions: Partial<JsonReadOptions>
Detection Sensor Module Config
Generated
from message meshtastic.ModuleConfig.DetectionSensorConfig